The residential journey
A clear process from concrete evaluation to final walk-through.
Each step supports adhesion, finish consistency, and a return-to-use plan you can follow with confidence.
Estimate my floor- 01
Plan the project
Share the room type, approximate dimensions, current surface, finish preferences, and timing. That gives the site visit a useful starting point.
- 02
Evaluate the concrete
Inspect existing coatings, cracks, pitting, contamination, moisture indicators, edges, drainage, and access before defining the scope.
- 03
Prepare the slab
Mechanically profile the concrete and remove dust, weak surface material, and incompatible coatings so the specified system has a sound surface to bond to.
- 04
Repair and detail
Address cracks, spalls, transitions, joints, and edges included in the proposal before the finish layers are installed.
- 05
Install the coating system
Apply the specified base, broadcast or finish layers, and topcoat within the manufacturer’s temperature, recoat, and cure requirements.
- 06
Inspect and hand off
Review the completed floor, care guidance, and the approved timing for foot traffic, equipment, and vehicles.
Why preparation matters
The finished floor depends on the surface below it.
Coatings bond to properly prepared concrete—not dust, weak surface material, paint, or contamination. Careful profiling and repair create consistent conditions for the specified coating system.
Next step
Ready to plan your floor?
Start with your room dimensions and surface condition to receive an estimated investment range.
Estimate my floor